If the bolt contacts the balancer shaft, turn the oil sprocket 1 rotation. Lift off the cylinder head assembly and remove the head gasket. View of the special tools needed to support the engine during mount removal D. Volume airflow sensor with built-in air intake temperature sensor and barometric pressure sensor 9. Tighten the exhaust rocker shaft mounting bolts to 106-124 inch lbs.
This redesign helped to increase fuel economy. Refer to the accompanying illustration for tightening specifications. Page 22 Back to Top 2. Move the rocker arms from side to side before tightening the shaft bolts to 21-25 ft. Carefully support the transaxle with a jack, slightly raise the transaxle, then remove the transaxle mount.
Insert an L-shaped hexagon wrench, etc. Insert a pin or wire into the holes. Matchmark the clamp to the hose before removal. Lift the tensioner in the direction of the arrow, then apply 22-30 inch lbs. Screw the tool in until it contacts the timing belt tensioner arm. Do not place an intact undeployed airbag face down on a solid surface. Torque all retaining bolts to specifications.
If the journals are binding, check the cylinder head for damage. Temporary alignment of the timing belt tensioner pulley 13. If necessary, remove the lower timing belt cover and alternator mounting bracket. Connect the negative battery cable. Inspect the bearing journals on the camshaft and the cylinder head. Torque the bolts to 80 inch lbs. Tighten bolts an additional 4 5.
Make sure the timing marks are properly aligned, while the tension side of the belt is correct. Failure to follow safety and disabling procedures could result in accidental air bag deployment, possible personal injury and unnecessary system repairs. Install or connect the following: Negative battery cable Front and side engine undercovers 3. Before servicing the vehicle, refer to the Precautions section. Fill the coolant system and engine crankcase. Output current test connections 8. Use the special tool between the oil pan and block in area B only.
Adjust the engine speed by gradually decreasing it until the value displayed on the ammeter is 30 A. Connect the negative battery cable. Point -B- intake cam low speed cam -B- 1. Use a puller as shown to separate the wheel bearing from the hub 2. Remove the tire and wheel assembly.
Do not use a replacement airbag that is not in the original packaging. Install the oil pan drain plug with a new gasket and tighten to 29 ft. Make sure the oil hole of the bearing is aligned with the oil hole of the cylinder block. Loosen the cylinder head mounting bolts in 3 steps, starting from the outside and working inward. Remove the intake manifold stay.
Insert the wire or pin removed in Step G, and make sure it can be pulled out with a light load. Install the oil pan drain plug with a new gasket and tighten to 29 ft. Remove or disconnect the following: Negative battery cable Timing belt Crankshaft sprocket Crankshaft key 3. Raise and support the vehicle safely. Slide the tool sideways to separate the oil pan from the block.
Remove the strut upper mounting nuts, insulator clip and stiffener plate. Install the seal in the case using the proper size seal driver. Start the engine and check for any exhaust leaks. Pull out the screwdriver and screw the plug back in. Remove the strut upper mounting nuts, insulator clip and stiffener plate.