Determining compatibility of tire and vehicle load capacities. This is to aid the consumer in making an in- formed choice in the purchase of tires. Just after driving or while the engine is warm, the en- gine oil level reading may be in a range between the upper level and the notch mark. Remove the fuel filler cap by turning it slowly coun- terclockwise. When the compass is on, an illuminated compass reading will appear in the lower part of the mirror.
However if you have no choice but to Keep the rear gate closed while driving to drive, stop drinking and sober up completely before prevent exhaust gas from entering the vehicle. The engine will resume running normally after the engine speed is reduced below the red zone. In a sudden stop or collisions, loose equipment could strike occupants and cause injury. Press the eject button 4. Open the cover flaps to use the tether anchorages. The horn will sound twice to indicate that the transmitter has been programmed. There seems to be no way an owner of this year Forester can read out the error codes.
Depress the brake pedal and start the engine. Most common causes of corrosion. Examples of such accidents are il- lustrated. This is not a problem I anticipated having to fix ever. Remove the upper and lower screws.
This could lead to an accident and possibly result in severe personal injury. Locking and unlocking from the inside. If turning the key is difficult, turn the steering wheel slightly to the right and left as you turn the key. Fill to the upper level with dis- tilled water. Check the tire pressures when the tires are cold.
That could cause leakage of gas from the stays, which may result in their inability to hold the rear gate open. Chapter 9: In case of emergency. The following precautions should be ob- served in order to ensure that the Vehicle Dy- namics Control system is operating properly: —. A running engine can be dangerous. Thus won't pass Bernallilo county emissions test.
Vehicle symbols There are some of the symbols you may see on your vehicle. P Park This position is for parking the vehicle and starting the engine. These lights stay illuminated for approximately 30 seconds if any of the doors or the rear gate is not opened. Two click stop positions of the dial may help you to aim at your desired interval. To turn off the cruise control There are two ways to turn off the cruise control: Push the main switch again. Do not use oil or grease on the wheel studs or nuts when the spare tire is installed.
Do not use sharp instruments or window clean- er containing abrasives to clean the inner sur- face of the window on which the antenna is printed. When the vehicle is headed up the hill, the front wheels should be turned away from the curb. A must read manual that is written from hands-on experience based on a complete teardown of the vehicle. Clean the inside of the air cleaner cover and case with a damp cloth and install a new air cleaner ele- ment. Even with the mirror in anti-glare mode, the mirror sur- face turns bright if the transmission is shifted into re- verse. If windshield washer fluid is unavailable use clean water.
Depress the accelerator pedal until the vehicle reaches the desired speed. Make sure the cables are replaced in the cor- rect order. When ordering an extender, only or- der one particularly designed for your vehicle. When the seats are not occupied, lower the head re- straint to improve rearward visibility. The storage bucket is put on the spare wheel. This could cause the nuts to become loose and lead to an accident.
Check that all windows, mirrors, and lights are clean and unobstructed. Otherwise, damage to the roof or paint or a dangerous road hazard due to loss of cargo could result. Do not make sudden downshifts. The roof rail must never be used alone to carry car- go. Cold temperatures re- duce battery capacity. This was in winter time. Traction Control Function The traction control function is designed to prevent spinning of the driving wheels on slippery road surfac- es, thereby helping to maintain traction and directional control.
To lower it, push the head restraint down while de- pressing the release button on the top of the seatback. Always check that the hood is properly locked before you start driving. Take up the slack in the lap belt. To lock the doors, push the front side of the switch. After confirming that the webbing is not twisted, in- sert the connector tongue attached at the webbing end into the buckle on the right hand side until a click is heard. When you do checking or servicing in the engine compartment while the engine is running.