See Engine Oil on page 5-14. The light will go out when the cruise control is turned off. Install the two pins and snap the ends into their locked position. Push the head restraint down to lower it. Be sure to use the correct wheel nuts. To help make sure your restraint systems are working properly after a crash, have them inspected and any necessary replacements made as soon as possible. Be sure that the inside surfaces of the rear side windows are not scratched and that the lines on the glass are not damaged.
Lower or raise the entire seat cushion by moving the whole control up or down. Find a service center Cadillac outside the boundaries of major cities will not be easy and it is well known to every owner of this brand. Find your current location and variance zone number on the following zone map. When to Check Lubricant Refer to the Maintenance Schedule to determine how often to check the lubricant. Slide the headrest pins into the holes on the top of the seat cushion to store the headrest.
Do not use fuel containing methanol. The aim has been preset at the factory and should need no further adjustment. Be aware that there are special things to know about safety belts and children. Use the wheel wrench to loosen all the wheel nuts. Then you have to bring up your foot and do it. If your child restraint manufacturer recommends using a top tether, attach and tighten the top tether to the top tether anchor.
The children or others could be badly injured or even killed. Your vehicle will roll backwards very quickly and you could go out of control. And, if you do get moving, poor steering and difficult braking can cause you to slide out of control. A top tether anchor is built into the vehicle. Pull the bulb straight out from the socket. Tapes longer than that are so thin they may not work well in this player.
The trailer tongue weight A should be 10 percent to 15 percent of the total loaded trailer weight B , up to the maximum of 1,000 lbs 454 kg with a weight distributing hitch. This system is designed to make installation of a child restraint easier. The parental control button might have been turned on. If you must drive with the liftgate open or if electrical wiring or other cable connections must pass through the seal between the body and the. This feature assists in starting the engine and protects the electrical system. The information give you handy reference that includes comprehensive explanation of how to perform all install,assembly,removal,replace,disassembly,adjust and inspect operations and Notes,Caution,Warning before completing procedures,let you get a better,in-depth understanding for your vehicle,and use an inexpensive way to keep your car in top shape.
Push the latches away from you, starting with the left latch, to lock the panel in place. That could cause injury to the person sitting there. Assemble the wheel blocks and jack together with the wing nut by reversing Step 2 under Removing the Spare Tire and Tools on page 5-82. Pull the rest of the shoulder belt all the way out of positioned so you would be able to unbuckle the the retractor to set the lock. To turn any lamps back on when in the off mode, turn the knob to the desired lamp mode. See Power Seats on page 1-2.
Application Cooling System Engine Driven Fan Electric Engine Cooling Fan Engine Oil with Filter Fuel Tank Transfer Case Fluid Wheel Nut Torque All capacities are approximate. Cleaning the Mirror When cleaning the mirror, use a paper towel or similar material dampened with glass cleaner. Connect it to the positive + terminal of the good battery. Close both cross locks at the center of the strap system to secure tightly. See Outlet Adjustment on page 3-27.
It will alert you to change your oil on a schedule consistent with your driving conditions. This feature is designed for shorter drivers, since the pedals cannot move farther away from the standard position, but can move closer to you for better pedal reach. Never pull on the hooks at a sideways angle. It is a theft-deterrent feature. Route the top tether according to your child restraint instructions and the following instructions: If the position you are using does not have a head restraint and you are using a single tether, route the tether over the seatback. This will help reduce the effect of trailer tongue weight on the rear axle. Then you have to bring up your foot and do it.
The cupholders are located in the center console for the front passengers and on the rear of the center console for the rear passengers. They also let police know you have a problem. You could have a crash and you or others could be killed. Make sure the retainer is seated in the wheel opening. It is an alphabetical list of what is in the manual and the page number where it can be found. Use the wheel wrench hook that allows you to pull the hoist cable towards you to assist in reaching the spare tire.
Be sure to use an anchor located on the same side of the vehicle as the seating position where the child restraint will be placed. The hooks could break off and you or others could be injured from the chain or cable snapping back. Watch out for the engine cooling fan. The front overhead console and the rear controls are used to adjust the climate. That could cause injury to the person sitting there. If you slam the door on it, you can damage both the belt and your vehicle. If there is interference or static, unplug the item from the accessory power outlet.