Such unnecessary use could result in serious personal injury in the event of an accident. Using a fuel other than that specified could adversely affect the emission control devices and systems, and could also affect the warranty coverage validity. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible. Tons of pictures and diagrams at your fingertips!! While holding the wire of the male terminal, try to insert the male terminal into the female terminal. Top tether strap anchor points P.
Do not use E-85 fuel 85% fuel ethanol, 15% unleaded gasoline unless the vehicle is specifically designed for E-85 fuel i. When the load is removed from the cargo area, the rear seat anchors automati- cally return to the unfolded position. Door locks, keyfob, keys P. Observe the following instructions before diagnosing. This will fold the seat base toward the back of the vehicle. Forward and backward Moving the switch forward or backward will slide the seat forward or backward to the desired position. Before diagnosing a problem, familiarize yourself with each symbol.
In addition to the general information in this manual, child safety information is available from many other sources, including doctors, teachers, government traffic safety offices, and community organizations. Make sure you have not inad- vertently created a new incident during your diagnosis or repair steps. If connector numbers and titles are shown in the Reference Area of the wiring diagram, these connector symbols are not shown in the Connector Area. Torque member mounting bolt 13. The reclining feature allows adjustment of the seatback for occupants of different sizes for added comfort and to help obtain proper seat belt fit. Ac- cording to accident statistics, children are safer when properly restrained in the rear seat than in the front seat. Test group number is shown in the left upper portion of each test group.
Release the connector tongue by inserting a suitable tool such as a key into the connector buckle s A. The second method is to put the suspect component into a freezer long enough for any water to freeze. To probe each terminal, remove the connector retainer to make con- tact space for probing. Rear sonar system off switch if so equipped P. To adjust the head restraint forward or backward Type B only , push it in the direction required.
Terminal Lock Inspection Check for unlocked terminals by pulling wire at the end of connector. Please read through this manual before operating your vehicle. Refer to Ground Inspection described later. Be careful when folding and unfolding. Therefore, be sure to receive all keys from vehicle owner.
Be sure that the seal is installed properly. Detectable Lines and Non-Detectable Lines In some wiring diagrams, two kinds of lines, representing wires, with different weight are used. The interior measurements are massive, generating the Quest sense unbelievably spacious. Release the lever to lock the seat in position. Standard value: Tolerance at inspection and adjustment.
This lighting up indicates that the anti-theft is not functioning, so prompt service is required. This vehicle is delivered to you with confidence. Torque member mounting bolt 13. If multiple wires are cased in one eye- let make sure no ground wires have excess wire insulation. Then check for loose connection by gently shaking the wiring or components as previously explained. Using the wiring diagrams inspect the wiring for continuity. Make sure to avoid damaging pipes, tubes, etc.
They could unknowingly ac- tivate switches or controls. Gently shake each connector and harness while monitoring the system for the incident you are trying to duplicate. The belt should be away from your face and neck, but not falling off your shoulder. Also with regard to tightening torque of bolts and nuts, there are descriptions both about range and about the standard tightening torque. The child restraints should be replaced if they are damaged.