The vehicle strikes an object, such as a telephone pole or sign pole. Failure to follow this procedure could result in injury to a child operating the power window. The red mark on the lock lever appears when the door is unlocked. This number is needed to make a replacement key if you lose your key or lock it inside the vehicle. When a heavy article is placed on the seat. Driving with the moonroof fully open can cause an annoying sound to generate at high speeds. Do not inject any tire liquid or.
For a single wipe of the wipers, pull the lever toward you. Jack Bathroom scale The tongue load can be weighed with a bathroom scale as shown in the illustration above. It is also for their own safety that pets should be properly restrained in your vehicle. After drawing out the seatbelt, pass it through the belt guide. Be sure not to use a hard cloth, thinner, benzine, alcohol, etc.
If you must drive under these conditions, drive only with all windows fully open. If the light illuminates while driving or does not turn off after the engine starts, stop the engine at the first safe opportunity and check the engine oil level. It drives fine etc but it has had at leas 4 or 5 recalls since I had the car. Radio operation: refer to page 5-10. Sit well back in the seat. When the transmission is shifted into reverse, the rear wiper will switch to continuous operation. The sun shade will also be opened together with the moonroof.
In an accident, this can increase the risk or severity of injury to the child. When any button of the remote transmitter is pressed, radio waves are sent and may affect the operation of the airplane. The factory-fitted tires are all-season tires. Keep the belts free of polishes, oils, chemicals and particularly battery acid. Repairs needed as a result of using the wrong refrigerant are not covered under warranty.
Program the number into the system in accordance with the following procedure: 1. Never use different brands together. Seat not as comfortable on back and neck as could be. Always make sure that all doors and the rear gate are locked before leaving your vehicle. Therefore a driver of an oncoming vehicle may experience too much glare when your headlight beam height adjustment is high due to the vehicle carrying heavy load. The following components are monitored by the indicator:.
The next owner will need the information found herein. You can use it to quickly find something you want to read. If it is not held tight and secure, the danger of your child suffering personal injury in the event of an accident may be increased. The resulting loss of vehicle control could lead to an accident. I solved the problem by turning the headrest around with the back forward, which provided less protection. Using a Phillips screwdriver, remove the upper and lower screws that secure the rear combination light assembly. I wish I had gotten the bigger engine.
If the fluid level is extremely low, it may indicate possible leakage. If this light still illuminates while driving after adjusting the tire pressure, a tire may have significant damage and a fast leak that causes the tire to lose air rapidly. The gear position indicator shows the currently selected gear in the 1st-to-4th-gear range. Bi-level heating To direct warm air toward the floor: 1. When the transmitter battery begins to get weak, transmitter range will begin to decrease.
Open the doors and get out of the vehicle. If an accident occurs, this can increase the risk or severity of injury to the child. I have resorted to downshifting to slow car. When the compass is on, an 3-33 The mirror has a photosensor attached on both the front and back sides. . Do not let it come in contact with the eyes, skin, clothing or the vehicle.
If the same fuse blows again, this indicates that its system has a problem. Be careful not to hit your head or face on the rear gate when opening or closing the rear gate and when loading or unloading cargo. And when the engine is turned off, it takes a much greater effort than usual to steer. Side airbag sensor center pillar lefthand side. The standard bumper beam must be installed after you remove the trailer hitch.