The tire suppliers may have additional markings, notes or warnings such as standard load, radial tubeless, etc. See your authorized dealer for more information. If this message does not clear. Note: For some markets this feature will be disabled. Enter the vehicle, close all doors.
Allow the seat to dry thoroughly. Engine oil filler cap 10. Your primary responsibility is the safe operation of the vehicle. When you want to save money and do the job right the first time, turn to an online Chilton Ford Taurus repair manual. Have your tow truck operator refer to this manual for proper hook-up and towing procedures for your vehicle. While holding the steering wheel in place, pull the lever up to its original position to lock the steering column. See the Driving chapter for more information.
In some situations it may not detect vehicles at all or detect a vehicle later than expected. See Attaching child safety seats with tether straps and Recommendations for attaching safety restraints for children in this chapter for more information. If the back end of the vehicle is hit or damaged, then check with your authorized dealer to have your rear view camera checked for proper coverage and operation. A correct zone setting will eliminate this error. Ford recommends the use of a digital or dial-type tire pressure gauge rather than a stick-type tire pressure gauge. Each time you fill the tank, record the amount of fuel added in gallons or liters.
Such products could contaminate the side-airbag system and affect performance of the side airbag in a collision. Make sure the headlamp switch is in the off position, then open the hood. Restore your vehicle's steering precision and handling characteristics with this affordable replacement for maximum safety and stability. This message should disappear shortly. Reviewers say the transmission is one of the best on the market.
Drive only to the closest Ford Motor Company authorized dealer or tire repair shop to have your tire inspected. It wants to be a performance car, but comes up short in a few critical areas. Run the engine until it reaches normal operating temperature. Turn the heater fan on in both vehicles to protect from any electrical surges. There is no fluid reservoir to check or fill.
In addition, sun load and sunglasses may reduce the visibility of the warning lamps. Hard objects can injure you in a collision. Ford strongly recommends that drivers use extreme caution when using any device or feature that may take their focus off the road. The center of the lamp is marked by a 3 mm circle on the headlamp lens. Ford Motor Company recommends that caution be used with any vehicle equipped with a high load or device such as ladder or luggage racks. If replacement is required, it is recommended that you see your authorized dealer. Refer to Power windows earlier in this chapter.
Ford Motor Company shall not be responsible for any such programming changes. Within three seconds press the 3. Open the fuel filler door. Align the sealant canister with the temporary mobility kit housing. They are committed to meeting your service needs and to assuring your continuing satisfaction. Your primary responsibility is the safe operation of the vehicle.
Go to the front of the vehicle and release the auxiliary latch that is located under the front center of the hood. Unwrap the clear tube from the compressor housing. It is recommended that you keep the tag in a safe place for future reference. The following table tells you which transmission each code represents. Side-to-side visibility is a problem thanks to the high windowsills, and the high hood made it difficult to judge where the front end was. Whenever possible it should be installed and properly adjusted when the seat is occupied.
Locate the correct anchor for the selected seating position. The engine and transmission are well-matched, so you get good power pulling away from the line and while passing. For more information, visit your local Ford of Canada dealer or www. The camera system provides a video image which appears in the rear view mirror or. Note: At least two already programmed transmitters are required to perform this procedure yourself. To stop motion at any time during the one-touch operation, press the control a second time.