See Remote Vehicle Start 0 42. Brake gradually and avoid abrupt stops. Do not adjust the steering wheel while driving. The exterior lamps flash and the horn chirps three times. How to Wear Safety Belts Properly 0 68. Manual Rearview Mirror If equipped with a manual rearview mirror, push the tab forward for daytime use and pull it for nighttime use to avoid glare from the headlamps from behind.
See Vehicle Personalization 0 150. Do not adjust the steering wheel while driving. The hood is not closed. The paradox may well lie in the actuality of the car business jogging cold and hot, and the issue of delay time. To use the safety lock: 1. Pulling an interior door handle will unlock the door.
Turn the control knob to L Left or R Right to choose the driver or passenger mirror. Press and hold to turn the power off. Programming without Two Recognized Keys Key Vehicles Only Program a new key to the vehicle when a recognized key is not available. The curved character line that spans diagonally through the dashboard is a rare artistic touch for this part, so that there is a cloth or leather upholstery covering it. The system will not assist or alert if it detects that you are actively steering.
Move the control knob up, down, left, or right to adjust the mirror. Extending Engine Run Time The engine run time can be extended by another 15 mintues, if during the first 15 minutes Step 2 and 3 are repeated while the engine is still running. Key Cylinder Access To access the key lock cylinder: 1. Instrument Panel Fuse Block 0 298. See Reclining Seatbacks 0 62. The vehicle can be reprogrammed so that lost or stolen transmitters no longer work.
See Vehicle Personalization 0 150. When the brakes are applied and the vehicle is at a complete stop, the engine may turn off. Slide the seat to the desired position and release the handle. Air Delivery Mode Controls 4. Programming with Two Recognized Keys Key Vehicles Only This procedure is for adding a transmitter, not replacing a transmitter. Arming the Alarm System 1. Use voice commands whenever possible.
Head Restraint Adjustment Do not drive until the head restraints for all occupants are installed and adjusted properly. To achieve a comfortable seating position, change the seatback recline angle as little as necessary while keeping the seat and the head restraint height in the proper position. So, all passengers should wear safety belts properly and the doors should be locked whenever the vehicle is driven. Keep in mind that other conditions, such as those previously stated, can impact the performance of the transmitter. One of them is the Chevrolet Cruze Hatchback which showcased 2017.
See Manual Rearview Mirror 0 54. The traction off light i illuminates. The front side seats are comfy, with better bolstering in the leather seats than the towel. The hazard warning flashers are on. The key lock cylinder is covered with a cap. Avoid idling the engine for long periods of time.
Use the correct engine oil. See Head Restraints 0 60 and Seat Adjustment 0 61. See Vehicle Personalization 0 150. This can be manually overridden by pressing and holding Q on the power door lock switch. Move the seatback to the desired position, then release the lever to lock the seatback in place.
Insert the new battery, positive side facing the back cover. Pull the switch up to close it. The shutdown feature comes with all models that are equipped with automatic transmissions. See Automatic Dimming Rearview Mirror 0 54. Programming Keys to the Vehicle Only keys programmed to the vehicle will work. Insert a new battery, positive side up, pushing it down until it is held in place.